Tightening the control housing on 1st texas pistol grip models

Anybody know the trick?

------------"Cz's still bad to the bone".------------
Living on a big ass Astroid.
The woman that got my rib,I want it back.

The screw to tighten it is under the foam grip. ..peel it down from top

sekypaleo Wrote:
-------------------------------------------------------
> The screw to tighten it is under the foam grip.
> ..peel it down from top


Thanks,that's where it's at,lol

------------"Cz's still bad to the bone".------------
Living on a big ass Astroid.
The woman that got my rib,I want it back.

Just be careful not to strip it out.

Be careful rolling it back if the grip is older and more brittle..

Ive ripped them...the new they are the more flexible the older and more U.V. exposed and there easily ripped on roll down...

Keith

“I don't care that they stole my idea . . I care that they don't have any of their own”
-Nikola Tesla

I found tightening it did squat,surprised me that it wasn't lose but the square shaft that fits into the grip,the hole is oversized so I shot some goop in there and put the screw back in and tightened it up. It'll never wiggle again but it'll never come apart either,hope she never throws a rod..lol

------------"Cz's still bad to the bone".------------
Living on a big ass Astroid.
The woman that got my rib,I want it back.

yep some of them are just loose and tightening does nothing....

good luck with it ..

Keith

“I don't care that they stole my idea . . I care that they don't have any of their own”
-Nikola Tesla