EQX owners may find this info helpful (deals with coil ears).

Don’t know where these are bought. $15 though sounds reasonable.
[metaldetectingforum.com]



Edited 1 time(s). Last edit at 01/06/2020 01:27AM by tnsharpshooter.

I just printed my own.

======================================================

You can see my videos here: [www.youtube.com]
My blog is here: [thesilverfiend.com]

======================================================

silverfiend Wrote:
-------------------------------------------------------
> I just printed my own.


You have done some nice videos.
Looking at your blog too.

I’ve had one a good while now they work pretty well. If you have an aftermarket shaft like Anderson’s you will have to do a little modification

silverfiend Wrote:
-------------------------------------------------------
> I just printed my own.

Which slicer did you use? I'm trying to print the stiffiner, and the model is falling apart when sliced in both Simplify 3D and Prusa Slicer. I've never used Cura but will spool it up if that's what it takes. Thanks.

silverfiend Wrote:
-------------------------------------------------------
> I just printed my own.

Which slicer did you use? I'm trying to print the stiffener, and the model is falling apart when sliced in both Simplify 3D and Prusa Slicer. I've never used Cura but will spool it up if that's what it takes. Thanks.