Foam grip

I need to replace the foam hand grip on one of my Fisher cz3d's...No directions came with it...has anyone replaced these before...what's the best way to tackle this job..Thanks

Tennis racket grip material - a lot easier than drilling out blind rivets and replacing them.

Rick Kempf
Gold Canyon AZ- where there is no gold

Take the armrest off, Cut it off the grip.

Take the new grip, spray insides with super hold hair spray, quickly slide the new grip over the end of the s-handle, up into position. Let it dry. Wipe any spray off the exposed s-handle.

DeepTech Vista X with 3 search coils.
Works for me

Buy a roll of black duct tape. Neatly tape over the entirety of the old grip.

Sven1 Wrote:
-------------------------------------------------------
> Take the new grip, spray insides with super hold hair spray, quickly slide the new grip over the end
> of the s-handle, up into position. Let it dry. Wipe any spray off the exposed s-handle.

Heh you've been to the White's factory haven't you...

I worked in bike shops for over 20 years. We always used hair spray to install foam grips on handlebars. It works great.

.

Soapy water works as good and when it dries grip stays in place...However removing the the armrest could be a problem.....